MODBUS-RTU Device Address Converter
ADA-1040PC2

MODBUS-RTU Device Address Converter* The prices are given in the response to the offer.
  • Changing the address of device with the MODBUS-RTU / JBUS (RS232) protocol to the address accepted on the bus,
  • Baud rate and data format conversion between DEV and BUS,
  • Conversion TX, RX signals of RS232 standard to RS485/RS422 standard and inversely,
  • Operating on 2 or 4 wire buses in RS485/RS422 standard,
  • Baud rate setted on RS485/RS422 interfaces (bps): 300, 600, 1200, 1800, 2400, 4800, 7200, 9600, 14400, 19200, 28800, 38400, 57600, 76800, 115200, 230400.
  • Data format setted on RS485/RS422 interfaces: Data bit: 5, 6, 7, 8; Parity: None, Odd, Even; Number of stop bits: 1, 2,
  • Power supply 10 - 30 VDC stable min. 2W,
  • ~3kV= optoizolation in signal channel between RS485/RS422 (BUS) and RS232 (DEV),
  • 1kV= or 3kV= galvanic isolation between RS485/RS422 (BUS), RS232 (DEV) interfaces and power supply (depend on version),
  • Connection RS485/RS422 network and power supply via screw terminal block 2.5 mm2 .
  • DB-9F connector for cable connection of RS232 interface to PC, controller etc.,
  • Implemented short circuit protection and over-voltage protection on RS485 / RS422 network,
  • Implemented protection against power supply reverse connection,
  • Cover compatible with DIN 43880 standard– mounting in typical electro-installation unit,
  • Cover adapt to rail mounting according to DIN35 / TS35 standard,
  • Cover dimensions (W x D x H) 53mm x 62mm x 90mm,