No longer produced - replacement
ETHERNET to Current Loop CLO Converter
ADA-13028L

ETHERNET to Current Loop CLO Converter* The prices are given in the response to the offer.
  • Functioning on ETHERNET network - according to IEEE 802.3 specification,
  • 10/100BaseT physical layer,
  • Baud rate 10/100Mbps (auto-sensing),
  • Full or half duplex (auto-sensing) operating mode,
  • Protocols: TCP, UDP, DHCP, SNMP, SSL/TLS, Telnet, Rlogin, LPD, HTTP/HTTPS, SMTP, ICMP, IGMP, ARP,
  • WWW sever implemented for converter configuration,,
  • Configuration of net services according to user personal setting,
  • Static or dynamic IP address (added by DHCP verver),
  • Diagnostics of serial and network port,
  • Encoded transmission: DES (56-bit), 3DES (168-bit), AES (128/256-bit),
  • Functioning in modes: virtual serial port, serial bridge TCP, serial bridge UDP,
  • Functioning on 2 wire line according to Current Loop CLO specification,
  • Current Loop CLO baud rate up to 19,2 kbps,
  • Data format in accordance with RS232 interface specification,
  • Transparent for all protocols(in accordance with the specification of RS232 interface): MODBUS, DNP and other,
  • Power supply 10 - 30 VDC stable min. 3W (power adapter not included),
  • 3kV= optoizolation in signal channel between ETHERNET and Current Loop CLO interface,
  • 1kV= or 3kV= galvanic isolation between ETHERNET and Current Loop interface and power supply,
  • Connection Current Loop CLO network via screw terminal block,
  • Connection Ethernet interface via RJ45 connector,
  • Implemented short circuit protection and over-voltage protection on Current Loop lines,
  • Protection against power supply reverse connection,
  • DIN 43880 standard - mounting in typical electro-installation unit,
  • Rail mounting according to DIN35 / TS35 standard,
  • Dimensions (W x D x H) 53mm x 62mm x 90mm.