RS232 to Current Loop Converter
ADA-1021

RS232 to Current Loop Converter* The prices are given in the response to the offer.
  • Operating on 4-wire network in Current Loop standard,
  • Conversion TX, RX signals of RS232 interface,
  • Baud rate up to 38,4 Kbps (depending on the length of the line),
  • Transparent for all protocols: MODBUS, DNP, PROFIBUS and other,
  • Any format of transmission frame,
  • 0-20mA Current Loop active/passive transmitter, active/passive receiver.
  • External power supply from 10 to 30 VDC (standard) stabilized,
  • ~3kV= optoisolation in signal channel between RS232 and Current Loop interface,
  • 1kV= or 3kV= galvanic isolationbetween RS232 interface and power supply,
  • 1kV= or 3kV= galvanic isolationbetween Current Loop interface and power supply,
  • Connection Current Loop line and power supply via screw terminal block,
  • Connection RS-232 interface via DB-9F connector by the use of extension cable,
  • Integrated short circuit protection and over-voltage protection on Current Loop lines,
  • Protection against power supply reverse connection,
  • DIN 43880 standard - mounting in typical electro-installation unit,
  • Rail mounting according to DIN35 / TS35 standard,
  • Dimensions (W x D x H) 53mm x 62mm x 90mm.