ETHERNET to Current Loop Converter with MODBUS GATEWAY
ADA-13021MG

ETHERNET to Current Loop Converter with MODBUS GATEWAY* The prices are given in the response to the offer.
  • Operating on ETHERNET network- IEEE 802.3 standard,
  • 10/100BaseT physical layer,
  • Connecting via Rj45 connector,
  • Baud rate 10/100Mbps (auto-sensing),
  • Full or half duplex (auto-sensing) operate modes,
  • Protocols: TCP, UDP, DHCP, SNMP, SSL/TLS, Telnet, Rlogin, LPD, HTTP/HTTPS, SMTP, ICMP, IGMP, ARP,
  • Integrated WWW sever for converter configuration,
  • Configuration of net services according to user personal setting,
  • Static or dynamic IP address (added by DHCP server),
  • Diagnostics of serial and network port,
  • Encoded transmission: DES (56-bit), 3DES (168-bit), AES (128/256-bit),
  • Operating modes: virtual serial port, serial bridge TCP, serial bridge UDP, TCP sockets, UDP sockets, MODBUS Data Gateway,
  • Operating on 4-wire line in Current Loop standard,
  • Current Loop baud rates (bps): 50, 75, 110, 134, 150, 200, 300, 600, 1200, 1800, 2400, 4800, 9600, 14400, 19200, 28800, 38400,
  • Current Loop data format - Number of data bits: 5, 6, 7, 8; Parity checking: None, Odd, Even, Constantly 1, Constantly 0; Stop Bits: 1, 2,
  • Transparent for all protocols, which the data format is compatible with the above specifications of Current Loop interface eg MODBUS,
  • Integrated protocols converter MODBUS-TCP to MODBUS-RTU/ASCII (MODBUS Data Gateway),
  • Operating in modes: MODBUS-RTU Master/Slave and MODBUS-ASCII Master/Slave,
  • Power supply 10 - 30 VDC stable min. 3W (power adapter not included),
  • ~ 3000V= optoizolation in signal channel between ETHERNET and Current Loop interfaces,
  • 1000V= or 3000V= galvanic isolation between ETHERNET interface and power supply - depends on version,
  • 1000V= or 3000V= galvanic isolation between Current Loop interface and power supply - depends on version,
  • Connection Current Loop interface via screw terminal block,
  • Implemented short circuit protection and over-voltage protection on Current Loop lines,
  • Protection against power supply reverse connection,
  • DIN 43880 standard - mounting in typical electro-installation unit,
  • Rail mounting according to DIN35 / TS35 standard,
  • Dimensions (W x D x H) 53mm x 62mm x 90mm.