ETHERNET to Current Loop Converter with MODBUS GATEWAY
ADA-13021MG

ETHERNET to Current Loop Converter with MODBUS GATEWAY* The prices are given in the response to the offer.
ADA-13021MG converter is used for data transmission between devices equipped with Current Loop interface via LAN/WAN network. In the ETHERNET network converter can operate in Virtual Serial Port mode, TCP serial bridge mode, UDP serial bridge mode, TCP sockets, UDP sockets, MODBUS Data Gateway. The MODBUS Data Gateway converts MODBUS-RTU master/slave and MODBUSASCII master/slave protocol to MODBUS-TCP and inversely. This allows for integrate MODBUS-RTU/ASCII with MODBUS-TCP devices within one network.
Can be configured and managed via Internet browser – converter has implemented WWW server. ADA-13021MG has plug-in screw terminal block for connecting the Current Loop interface and power supply and RJ45 modular connector for ETHERNET network connection. The converter transmits data via Current Loop interface with maximum baud rate up to 38,4 kbps and uses signals RX+,RX-,TX+,TX- of CL interface.
To Current Loop line based on ADA-13021MG can be connected in point-to-point topology devices operate in half duplex or full duplex mode. This converter has internal, low energy surge protection for each Current Loop lines however it is recommended to use the external lightning arresters (typical protection of telephone line) for the lightning protection of lines. Has galvanic isolation between power supply and Ethernet interface and Current Loop and optoisolation between Current Loop and Ethernet interfaces.
The converter is adapted for powering from the regular voltage external source which value should contain from 10V to 30V. We provide with converter the drivers which installed in the operating systems (Windows 98ME,2000,XP,2003,Vista,7, 8.x, 10 ; Linux), will create an additional COM/TTY port. This port is the next free number eg COM3, can be used like a standard COM port.