RS232 to Current Loop 2-wire CLO Converter
ADA-1028L

RS232 to Current Loop 2-wire CLO Converter* The prices are given in the response to the offer.
  • Operating on 2-wire network standard of 0-20mA Current Loop CLO,
  • RX and TX signals conversion of RS232 interface,
  • Connection up to 4 device on Current Loop CLO network,
  • Baud rate up to 19,2 kbps,
  • Transparent for all protocols (half duplex transmission): MODBUS, DNP, PROFIBUS and other,
  • Power supply 10 - 30 VDC stable, 2W,
  • 5kV= optoisolation in signal channel between RS232 and Current Loop interface,
  • 1kV= or 3kV= galvanic isolation between RS232 interface and power supply,
  • 1kV= or 3kV= galvanic isolation between Current Loop interface and power supply,
  • Connection Current Loop network and power supply via screw termianl block,
  • Connection RS-232 network via Female DB9 connector,
  • Implemented short circuit protection and over-voltage protection on Current Loop circuit,
  • Protection against power supply reverse connection,
  • Casing compatible with DIN 43880 standard– mounting in typical electro-installation,
  • Rail mounting according to DIN35 / TS35 standard,
  • Dimensions (W x D x H) 53mm x 62mm x 90mm.