ETHERNET to Current Loop Converter with MODBUS GATEWAY
ADA-13020MG

ETHERNET to Current Loop Converter with MODBUS GATEWAY* The prices are given in the response to the offer.
The ADA-13020MG converter is used for data transmission between devices equipped with Current Loop interface via LAN/WAN network without interfering with data format. The converter can operate on the ETHERNET network in Virtual Serial Port mode, TCP serial bridge mode, UDP serial bridge mode, TCP sockets, UDP sockets, MODBUS Data Gateway.
MODBUS Data Gateway converts MODBUS-RTU/ SUNSPEC master/slave or MODBUS-ASCII master/slave protocols to MODBUS-TCP protocol and reverse. This allows integrating MODBUS-RTU/ SUNSPEC/ ASCII devices with MODBUS-TCP devices within a single network.
The ADA-13020MG converter uses for operating RX+,RX-,TX+,TX- signals and transmits data via current loop interface with maximum baud rate up to 38,4kbps via two pairs of twisted pair cable. The converter has screw terminal block for connection of Current Loop interface and power supply and RJ45 connector for Ethernet network connecting. To Current Loop interface can be connected one device in point-to-point topology, operates in half duplex or full duplex mode.
Over-voltage protection was made on base safety diodes and fuses on each Current Loop lines. This converter has also internal, low energy surge protection for each Current Loop lines however it is recommended to use the external lightning arresters (typical protection of telephone line) for the lightning protection of lines.
With converter are provided the drivers which installed in the operating system, will create an additional COM port. This port is the next free number eg COM3, can be used like a standard COM port.