RS-485/RS-422 to Wi-Fi(802.11b) Wireless Serial Server with MODBUS GATEWAY
ADA-14040 - Currently Unavailable

RS-485/RS-422 to Wi-Fi(802.11b) Wireless Serial Server with MODBUS GATEWAY* The prices are given in the response to the offer.
  • Functioning with the data rates up to 11Mbps on the 2,4GHz frequency in the wireless network (IEEE 802.11b standard),
  • Baud rate in wireless network 1, 2, 5.5, 11 Mbps,
  • Modulation CCK(11/5 Mbps), DQPSK(2 Mbps), DBPSK(1Mbps),
  • sensitivity of receiver: -82dBm for 11Mbps, -87dBm for 5.5Mbps, -89dBm for 2Mbps, -92dBm for 1Mbps,
  • Channels number: 11 (USA/Canada), 13 (Europa), 14 (Japonia),
  • Antenna conection via SMA connector,
  • Wireless network security: WEP (64/128-bit encryption), WPA (128-bit encryption), WPA2 (128-bit encryption), PEAP, PSK (pre-shared key mode),
  • Protocols: TCP, UDP, DHCP, SNMP, SSL/TLS, Telnet, Rlogin, LPD, HTTP/HTTPS, SMTP, ICMP, IGMP, ARP,
  • WWW sever implemented for server configuration,
  • Drivers of virtual port COM,
  • Configuration of net services according to user personal setting,
  • Static or dynamic IP address (added by DHCP verver),
  • Diagnostics of serial and network port,
  • Encoded transmission: SSL v3.0/TLS v1.0 - DES (56-bit), 3DES (168-bit), AES (128/256-bit),
  • Functioning in modes: virtual serial port, serial bridge TCP, serial bridge UDP,
  • Transmited signals: Rx, Tx,
  • Functioning on 2 or 4-wire RS485 Bus,
  • Functioning on 4-wire RS422 Bus,
  • Baud rate of RS485/RS422 interface up to 230 kbps,
  • Any format of byte defined with the specification of RS232 interface,
  • Transparent for all protocols which data format is compatible with the specification EIA-232: MODBUS, DNP, PROFIBUS and other,
  • Stable external power supply 10 - 30 VDC,
  • 3W power consumption,
  • 3000V= optoisolation in signal channel between Wi-Fi and RS485/RS422 interface,
  • 1000V= or 3000V= galvanic isolation between Wi-Fi interfaces and power supply,
  • 1000V= or 3000V= galvanic isolation between RS485/422 interfaces and power supply,
  • Connection of RS485/RS422 interface via screw terminal block,
  • Implemented on RS485/RS422 interface short-circuit protection and surge,
  • Protection against power supply reverse connection,
  • DIN 43880 standard - mounting in typical electro-installation unit,
  • Rail mounting according to DIN35 / TS35 standard,
  • Dimensions (W x D x H) 53mm x 62mm x 90mm,
  • Antenna dimensions: length 110mm, diameter 9mm.